Download Cabletron Systems ESXMIM-F2 Specifications

Chapter 9: The Module Specific Setup Screen
9.1
DEVICE SPECIFIC SETUP SCREEN FIELDS
The following list describes each of the Device Specific Setup screen
fields:
Interface 1
This field displays the current connection status of the ESXMIM Interface
1. Interface 1 may be assigned to either the MMAC backplane Ethernet
Channel A or to the front panel ESXMIM port 1.
9.2
SELECTING INTERFACE 1 CONNECTION STATUS
To select the connection method that will be used by ESXMIM interface
1, perform the following steps:
1. Use the arrow keys to highlight the selection field next to the
Interface 1 display field. The default value for this field is
MMAC CHANNEL A
2. Press ENTER to toggle between the two connection method options
available for Interface 1; MMAC CHANNEL A or FRONT PANEL.
NOTE
The ESXMIM will only allow the default connection status to be
altered if an Ethernet link is detected on front panel port 1.
3. The ESXMIM will immediately switch to the connection method
displayed next to the Interface 1 field.
Page 9-2
ESXMIM/ESXMIM-F2 Local Management Guide