Download Mantis 5000 Specifications

•
•
•
•
•
•
•
•
•
Operation
o Routine DRA installation
o Removing the DRA from the instrument
o Collecting baseline scans
o 8°/h Reflectance Factor Measurements (Comparison Method)
o 8°/d Reflectance Factor Measurements (Comparison Method)
o 8°/h Reflectance Factor Measurements (Single Beam Mode)
o 0°/h Transmission Measurements (Comparison Method)
o 0°/d Transmission Measurements (Comparison Method)
o Variable Angle Reflectance Measurements (Center-Mount Sample
Holder)
o Absorbance Measurements (Cuvette Center-Mount Sample Holder)
o Using the Small Spot Kit
o Small Sample Masking Techniques
o Applying a Nitrogen Purge
o NIR reflectance measurements (Cary 5000 only)
o Specular-only reflectance measurements
Measurement calibration and corrections
o Calibration
o When should I perform a Calibration?
o Diagnostic scans
ƒ Energy scans
ƒ Baseline scans
ƒ Other scans
Maintenance
o Cleaning and Inspection
o Energy Scans
o Light Trap Zeroline Scan
o Mirror Cleaning Procedure
Standards
Troubleshooting
Spare parts
References
Alignment targets
Sample Mounting Kits