Download ZeissS S81 Technical data

71
Accessory interface
Electrical connections for accessory modules
The power supply for the electrical accessory components can be connected to connectors "A" on the interface plate (connectors for OR illuminators, terminal blocks B and C).
On-site requirements for the connection of accessories
g
Route the power lines in the building up to the interface plate.
g
Route any required control lines and/or monitor connections in the
building up to the interface plate.
g
Make sure (for in-wall installation) that a sufficient number of conduits
with sufficient cross section are provided.
g
Route additional lines for potential equalization to the terminals on the
interface plate.
Warning!
e The planning, execution and inspection of the on-site electrical installations must be performed by expert electrical technicians and officially registered electrical firms.
M-30-1382-en
e
The electrical installations of the room concerned must comply with
the requirements of the applicable national regulations. In the Federal
Republic of Germany, VDE 0107 applies.
e
The number of circuits is dependent on the customer's specific carrier
system configuration.
e
If several circuits are required by the customer, appropriate allowance
must be made on the interface plate.
e
Multiwire lines must be provided with wire end sleeves.
S8 / S81 Ceiling Mounts
Issue 12.0
Printed on 19. 11. 2007