Download Extron electronics FOX Matrix 7200 User guide

X6$ = Port timeout (10-sec. increments)1 (= 10 seconds) – 65000 (default is 30 = 300 seconds = 5 minutes)
X6% = SMNP port number
00000 (= disable) – nnnnn. Default = 00161. Leading zeroes are not necessary for entry.
X6^=SNMP contact name and locationUp to 64 alphanumeric characters. Default = Not•Specified.
X6& = SNMP community name
Up to 64 alphanumeric characters.
Default = public (for read community) or private (for read-write community).
X6* = Trap target
X6( = SNMP trap version
X7) = SNMP target 1 through 3
1–3
2 or 3, or 0 = empty (default) if no target set
70 – 72. 70 = SNMP target 1, ... 72 = target 3
Command and Response Table for IP- and SNMP-Specific SIS Commands
SIS Command
Response
(Host to Unit)
(Unit to Host)
Set matrix name
Read matrix name (location)
Reset matrix name to factory default
EX4)CN}
ECN}
E•CN}
Ipn•X4)]
Set time and date
Read time and date
Set GMT offset
EX4@CT}
ECT}
EX4$CZ}
IptX4@]
Example:
Read GMT offset
Set Daylight Saving Time
Read Daylight Savings Time
Set IP address
Read IP address
Read hardware address
Read # of open connections
Set subnet mask
Read subnet mask
Set gateway IP address
Read gateway IP address
Set administrator password
Read administrator password
Reset (clear) administrator
password
Set user password
Read user password
Reset (clear) user password
Set mail server, domainname
E8.3CZ}
ECZ}
EX4%CX}
ECX}
EX4^CI}
ECI}
ECH}
ECC}
EX4^CS}
ECS}
EX4^CG}
ECG}
EX4(CA}
ECA}
E•CA}
Ipz+08:30]
Read mail server, domainname
Set email recipient
ECM}
EX5!,X5@CR}
Command Function
Additional description
IP setup commands
Example:
EX4(CU}
ECU}
E•CU}
EX4^,X5),X4(CM}
X4)]
Ipn•X4)]
“FOX-Matrix-3 (7)-” plus the last
3 pairs of the MAC address.
X4#]
IpzX4$]
X4$]
X4%]
X4%]
IpiX4^]
X4^]
X4&]
X4*]
IpsX4^]
X4^]
IpgX4^]
X4^]
Ipa•X4(]
X4(]
Ipa•]
In the command, the divider between
hours and minutes can be either a
colon or a period. In the response, the
divider is a colon.
8.3 = 8:30
Reads MAC address.
Ipu•X4(]
X4(]
Ipu•]
IpmX4^,X5),X4(]
X4^,X5),X4(]
IprX5!,X5@,]
This command sets the email recipient.
To receive email notifications, you must
then set the events that the switcher
reports, using one or more separate
Set email (EM) SIS commands (on the
next page).
E69,[email protected]}
Ipr69,[email protected],]
Read email recipient
EX5!CR}
X5@,]
FOX Matrix 3200 and 7200 Switchers • Programming Guide
68