1
Download encoder position display unit
Transcript
Y The display unit goes into the distance-to-go mode when Program Input is activated. You can move to the entered positions simply by traversing to display value zero. The program blocks can be entered in absolute or incremental dimensions. The ∆ symbol in the status display continues blinking until the block is completely entered. 3 4 30 For small-lot production you can enter the sequence of positioning steps in the operating mode Program Input (PGM key). Up to 99 positioning steps are possible. The program remains in memory even when the power is turned off or otherwise interrupted. 1 2 20 Program Input Program Input 0 34 Tool data: Radius Length Axis Starting position: X Y Z 6 mm 50 mm Z -6 mm 0 mm 0 mm 30 0 Example: Milling a step 60 X You can start from any positioning block in a finished program.
