Download IM Manual 2/18/04

Transcript
Chapter 4: Setting Up Stations and Sensors, continued
Setting Inhibit Conditions
These cells allow you to set the conditions under which watering will be interrupted (until the condition is no
longer true) or canceled (for the remainder of the program). The possible values for the Inhibits When and
Inhibits Limit cells are determined by what is entered in the sensor Use cell to the left. The cells to the right of the
Limit cells display the unit of measure selected at the SETUP screen.
To set inhibit conditions:
1. With the SENSOR SETUP screen displayed,
Auto Stand-Alone
SENSOR SETUP
Type
1 S
2 S
3 S
4 P
5 P
6 P
Use
Freeze
Rain
–
ET
–
MVs 1 2 3
01:16 pm
Inhibits
When Limit
Closed
Open
0.06 Amps
01/01/2001
Units
Go to sensor– details
Freeze sensor
Page
Down
Sensor
Details
Clear
Row
Peripheral
Setup
use the arrow buttons to highlight the cell that corresponds to the sensor number and Inhibits When
characteristic, then press to cycle through the following choices:
Switch Sensors
• Open (the default value) — The sensor stops watering when the sensor circuit is open.
•
Closed — The sensor stops watering when the sensor circuit is closed.
Pulse Sensors
Note: To set inhibit conditions for pulse sensors, you must first enter information about the pulse sensors on
the SENSOR DETAILS screen. For more information, see Chapter 4, Setting Calibration for Pulse Sensors.
40
•
Never (the default value) — The controller will never stop watering because of the sensor.
•
< (less than) — The sensor will stop watering when the value is less than the amount in the cell to the right.
•
> (greater than) — The sensor will stop watering when the value is greater than the amount in the cell to
the right.