Download CommPAK I/O8 - Encom Wireless
Transcript
CommPAK I/O8 Wireless On/Off Control USER MANUAL Using Traffic Controller Outputs as Input Connections with the I/O8 Radio For example, if we are programming the outputs of another COMMPAK I/O8 the programming for the I/O configuration would be shown below: The following application shows you how to connect a Traffic Controller to the Input Connection of an I/O8 Radio. A Traffic Controller is an example of a device with Open Collector Outputs. Refer to the User Manual of your Traffic Controller or other equipment to determine if it is configured with Open Collector Outputs. The Controller Equipment open collector outputs are to have a Pull Up Resistor (10K ohm) installed. The Controller Equipment signal ground must be connected to the COMMPAK I/O8 ground. The Output 1 of our Remote Radio is going to be activated by Radio address 0 (this being our Master radio with the Open Collector input relay) and the corresponding Input number. Any Input can activate any Output. Connect each Controller Equipment open collector output to the COMMPAK I/O8 Inputs as shown below: For more information on configuring refer to the section on Configuring Your I/O8 Radio. You do not have to “program” the Inputs in the ControlPAK software. The programming is only on the Outputs of the either this radio or another radio. The Outputs are programmed so that the installed Open Collector Input is used as the activation switch for your system. Page 24 © 2009 Encom Wireless Data Solutions. All Rights Reserved