Download Wholehog Control System

Section 24: Cuelist Playback
Reference
• Go: if the cuelist is inactive pressing Go will activate it onstage. If the
cuelist is already active then pressing Go will run the next cue, or restart
paused fades (see Halt/Back below).
• Halt/Back: pauses any running fades. If there are no running fades then
pressing Halt/Back will start a fade back to the previous cue.
• Fader: controls the intensity of fixtures under the control of this playback.
When the fader is at full, fixtures appear on stage at their programmed
intensity. As the fader level is reduced, the intensity of fixtures is reduced
proportionally.
• Flash: momentarily puts the intensity of fixtures under the control of
this playback to their full programmed value, as if the fader had been
put to maximum.
You can customise the function of master controls to suit the requirements of the user
or a particular show; see Configuring Playback Controls (p.295).
Tip
Pressing or clicking on the Playback Bar is equivalent to pressing that master's
Choose key.
The Main Controls
The main playback controls, positioned to the right of the masters (see Figure 24.2, “The
Main Playback Controls”) work with the currently chosen master. You can also use them
with another master by holding down the required Choose key while pressing a key
from the main controls.
Choose key
Assert key
Release key
Goto key
Skip forwards
Skip back
Halt/Back key
Go key
Figure 24.2. The Main Playback Controls
Flying Pig Systems
249