Download 5. integra control panel

38
User Manual
INTEGRA
6.14 ANSWERING PHONE CALLS
The users having a telephone code (not to be confused with the acknowledgement code for
receipt of a telephone message) can use the call answering and telephone control functions.
The call answering function allows the control panel users to obtain the partition status
information (armed mode, alarms) to which the user has access. Owing to the telephone
control function, the users with a telephone code can use telephone to control the REMOTE
SWITCH outputs. The installer defines which switchs can be controlled by the given user.
The call answering and telephone control functions require that a telephone with DTMF tone
dialing be used.
Note: Not all cellular telephones allow control in DTMF tone system.
How to use this function:
• Dial the telephone number (line) of the control panel. The method of dialing is defined by
the installer. The control panel may establish connection after a defined number of dialing
signals (rings). The dialing can be single or double. When double dialing is used, wait until
a defined number of “rings" is completed, put the handset off, and then dial the control
panel telephone number again. After the number is dialed the second time, the control
panel should answer immediately.
• After the connection is established, the control panel is ready to receive the user telephone
code – three short beeps (handshake).
• Enter the code from the telephone keypad (in tone system). The control panel will
acknowledge the correct code with a series consisting of four short and one long beeps.
Two long beeps follow receipt of an incorrect code. If the entered code is invalid, the
control panel will signal it by two long beeps and will not be answering any calls for the
next 4 minutes.
• The control panel is in partition status information mode. It waits for user’s response for 15
seconds, generating one short beep every two seconds. You are expected to enter the
partition number from the telephone keypad (in two-digit format, e.g., 01; 05; 12; 25).
If there is no response within this time, the control panel will ring off.
• After the partition number is entered, the control panel generates the message. Three
short beeps inform that the partition is disarmed and four short and one long beeps mean
that the partition is armed.
• Alarm memory is the extra information given by the control panel. If an alarm occurred in
the partition, the control panel generates a series of double beeps – one lower and the
other higher – following the partition status information. If there was no alarm, the control
panel will generate a single short beep every two seconds.
• In order to proceed to the control of the remote switches status, press [2] and [#] on the
telephone keypad. After the control function is entered, a periodic signal in the form of two
short beeps can be heard in the receiver.
• Now the control panel waits for the (two-digit) switch number to be entered. Entering the
telephone number from the telephone keypad will switch the relay status to the opposite
one. Three short beeps mean that the relay is switched off and four short and one long
beeps - that the relay is switched on. Each time you enter the same number, the relay
status is changed to the opposite one.
• It is possible to move back to the partition status indication mode by pressing in turn the [1]
and [#] keys.
• Pressing in turn the [0] and [#] keys will exit the function and terminate the telephone
connection.