Download 5. integra control panel
Transcript
INTEGRA SATEL 49 In the first two cases, the procedure of entering a new code is simple: having started the function, enter the new code and confirm it by pressing the [#] key. If the code has been guessed, the procedure is more complicated, as it requires confirmation of the code change by the master user or the serviceman: having entered the new code, confirmed by pressing [#], it is necessary to enter the master code or the service code (in case the master user code has been guessed). Note: Using the service code is possible after enabling the service access by the master user. It is possible for the service to activate the option which blocks creating easy-to-guess codes. When this option is activated, the control panel does not allow to create such codes as e.g. 1111, 1234, 1122 etc. These codes will be rejected, and the control panel will wait for another combination of digits. Note: The control panel does not recognize the code which is identical to the old code as a new one. Change prefix This function, which is available to the master user only, makes it possible to change the system prefixes. (see page 27). The installer, using the corresponding service function (ÆSERVICE MODE ÆOPTIONS ÆPREFIX LENGTH), can determine the prefix length (1–8 digits). If the length of prefixes programmed by the installer is 0, the function forcing the prefixes to be inserted before the user function will be disabled. If prefixes (NORMAL and DURESS) are used in the security alarm system, the master user of each object must change the default setting of the prefixes and define the time period to the next change (1–255 days). Masters This function is used for entering new users with master authority level, changing data related to the existing master user, or for removing the master user. Only the installer having a service code is authorized to use this function. Only one user with such authority level may be assigned to each object. The list of all rights which may be assigned to the master user is identical to that shown in the description of the USERS function. The function makes it possible to select the keypads, locks and card readers which could be operated by the given master user. The introduced changes become valid in the system as from exiting the function by pressing the [*] key and accepting the changes with the key [1]. Note: In order to create a new administrator, an access code must be assigned to him. Users This function makes it possible to enter new users in the system, as well as edit or remove the existing ones. Note: A user will be created after at least one identifier is assigned to him: an access code, proximity card, DALLAS chip or key fob. For each user, the following can be defined: Code – a password assigned to the new user (if the new user is authorized to change his own code, he should change it!). The password that has been changed cannot be intercepted in the DLOADX and GUARDX programs. Telephone code – a code by which the system will recognize the user in the answering phone calls function. If this code is not assigned, the user will be unable to check the