Download 310-S USER`S MANUAL

Transcript
II
Safety
Observe and Obey All Warnings Listed Below
 Do not operate without proper training.
 Personal Protective Equipment:
o Always wear safety goggles;
o Abrasion-resistant gloves are recommended when handling
sharp tools, workpieces and workpiece pallets. Caution must
be taken as gloves may become entangled in rotating or
moving parts within the machine.
 The electrical power must meet the specifications in this manual.
Attempting to run the machine from any other source can cause
severe damage and will void the warranty.
 DO NOT power up machine until after the installation is complete.
 NEVER service the machine with the power connected.
 Improperly fastened parts machined at high speeds/feeds may be
ejected and puncture the protective lid. Machining oversized or
marginally fastened parts is not safe.
 The window in the protective lid must be replaced if damaged or
severely scratched - Replace damaged windows immediately.
 Do not process toxic or flammable material. Deadly fumes can be
present. Consult material manufacturer for safe handling of material
by-products before processing.
 The machining process may generate fine, dust-like swarf.
Depending on the workpiece material, appropriate care (for example
vacuum swarf removal) must be taken to properly handle the swarf.
Consult material manufacturer for additional information.

7
The machine must be periodically cleaned to remove residual swarf.
The user is responsible for establishing a cleaning process and
schedule, as required by material removal rates, workpiece material,
and other factors.
Safety
September 2011