Download Feature Manual - ECAP - Oracle Documentation
Transcript
Feature Manual - ECAP Condition Maintenance Resolution 3. Perform a network health check (see Network Check). If not successful, configure the ECAP network using platcfg (see Configuring ECAP Network Interfaces). Data files are zero length The ECAP disk is probably full. This causes the filename to be generated, but no data is stored in the file. Remedy: 1. Check available disk space (see Disk Check). 2. Verify that FileMover and FileScrubber are periodically running (see Crontab Check) and configured correctly via ecapcfg. If not, re-run ecapcfg to set up the processes and/or start the ECAP processes (see Configuring the Integrated Accounting Feed Application). Data file contains no records The data file contains standard data header but no record entries. This occurs when no MSU records are received from EAGLE 5 ISS. There are no SLAN cards in the IS-NR state. Remedy: 1. Use the rept-stat-slan command to verify that the EAGLE 5 ISS SLAN subsystem is IS-NR and is sending MSU packets to ECAP. Refer to the Commands Manual for information on the rept-stat-slan command. 2. Verify gateway screens are properly configured (see Configuring Gateway Screening). The EAGLE 5 ISS SLAN card will only copy MSUs that have been screened. Data file contains no tag for incominglinksetname/outgoinglinksetname The data file contains standard data file header with the record entries, but the tag entry for incominglinksetname and outgoinglinksetname is missing. Remedy: 1. Use the rtrv-ss7opts command to determine whether the SLANLSN parameter on EAGLE 5 ISS is set to ON. This parameter can be set using the chg-ss7opts command. 910-5784-001 Revision B, December 2009 62