Download Solutions Plus™ Programmer/Controller User Manual Version 3

21
The chart on the preceding page shows the different analog input types used by the Solutions Plus.
The Analog Devices modules used have a hex code for there initial setup that does not coincide with the
codes used in the Solutions Plus. For example, if you use a type "T" thermocouple, the hex code on the
Analog Devices module 6B11 would be 10. You would select number 16 in the Solutions Plus analog
device type selection page.
If the instrument is equipped with the 8AD module connected to the PLC rather than the Analog Devices,
then the addresses are by channel. Channel 1 address will be 701 and each following channel will
increment this address by one. For example, channel 3 will have an address of 703.