Download Solutions Plus™ Programmer/Controller User Manual Version 3

36
set slope channel = value
set slope units = value
sets the slope units for a specified channel. Example:
set slope 1 = 2.1
sets the slope units for a specified channel. Example:
set slope units 1 = upm Valid entries are ups, upm, and uph. These
represent units per second, units per minute and units per hour
respectively.
set slope hold =Boolean sets the slope hold. Example: set slope hold = off
set slope release =Boolean sets the slope hold. Example: set slope release = on
read slope channel
reads the slope value and units for a specified channel. Example:
read slope 1 may return 2.1 upm