Download MT-151_HMI-user-manual

8.1.6.5.2.5. SMS text
Function
- Allows to enter text which will be send as SMS
Data type
- Text
Range
- Letters, numerals and special characters - max. 160
characters
Default value
- N/A
Comments
- It is possible to add to SMS text macros, symbolic names and
special mnemonics dynamically changed for values from
module, e.g. analog input value or binary input state.
Description of this mnemonics can be found in SMS
commands syntax chapter in Appendices.
Parameter is visible only when Transmission type parameter
is set to SMS.
8.1.6.5.2.6. Data block
Function
- Defines data block which is sent via GPRS by rule
Data type
- Selection list
Range
- None and events defined in Data block table
Default value
- None
Comments
- Parameter is visible only when Transmission type parameter is
set to GPRS.
8.1.6.6. SNMP
Subgroup SNMP contains a list of transmission tasks performed by the module using
SNMP (Supports Traps and Requests).
8.1.6.6.1. Use of SNMP
Function
- Turns on/off SNMP protocol handling
Data type
- Selection list
Range
- Yes
No
Default value
- No
Comments
- N/A
SNMP is enabled
SNMP is disabled
8.1.6.6.2. Community string - read
94 Function
- Password required to access module resources. Read-only
access
Data type
- Text
Range
- Letters and numbers, max. 31 characters
Default value
- public
Comments
- N/A