Download INSTALLATION MANUAL

CONTROL PORTS AND PROTOCOLS - continued
The Outputs
There are thirty-two general purpose outputs, located on the
three Tally connectors (25 way D-type) on the rear of the
switcher mainframe. Each output may be independently
programmed to “indicate” any one of a wide range of
occurrences or combinations of occurrences. These
occurrences fall into five groups (six if the Quad DSK option is
fitted) which are detailed below.
Video Tally
Bus Tally
Trans Running
Each output may be set to Tally any one of the video inputs.
The use of a particular bus may be tallied.
The transitions, Fade to Black, Program / Preset, DSK or M/E
are tallied. If the Quad DSK option is fitted the four external
DSK transitions may be tallied.
T/L Running
A particular timeline may be tallied, including those of an
external DSK, where fitted. Also a Tally may be generated if
any timeline is running.
T/L User Bits
Six “flag” bits are available which can be linked to specific
keyframes on specific timelines. These bits may be used as
tallies.
Ext DSK Tally
Key Action
Note
S&W Production & Post Productio
The background, key fill and key cut signals of the four (option)
external DSKs may be tallied.
Manual tallies may be triggered from Skateboard.
A complete list of all of the “occurrences” which may be tallied
on the General Purpose Outputs (GPO) is on page 28.
SD1512 Installation Manual - Issue 8, Rev 1
Page 25