Download installation manual

4. SUMMARY OF ALARM SYSTEM SETTING SEQUENCE.
CONTROL
CONDITION
ACTION
TIME
DIRECTION
INDICATORS
SIREN
SYSTEM
LED
Doors opened / -
PIN ENTRY
-
-
-
Double flashing /
long flashes
PIN entered
FN ENTRY
8 minutes
-
-
Double flashing /
long flashes
FN entered, ignition OFF /
secret button not pressed
SN CHECK
8 minutes
5 series of flashes (2 second pause
between series) number of flashes
in series corresponds with SN
-
Frequent flashing
FN entered, ignition ON /
secret button pressed down
SN CHANGE
8 minutes
Flashes every 3 seconds,
afterwards 5 series of flashes
Indicates
SN change
Double flashing
Nustatymø
pabaiga
FN=11
ENTRY
8 minutes
-
-
Double flashing /
long flashes
5. NOTIFICATION ABOUT OPEN SYSTEM INPUTS, DATA ABOUT LAST TRIGGERS.
If system was triggered in armed state, direction indicators will flash four times when disarming the system (depends on alarm system settings).
'GN6I.a' stores the data about last three triggers. This feature enables to ascertain the causes of the false alarm. There are two ways to do that:
1. System LED indicates the cause of the last trigger. After disarming turn the ignition ON and count the LED flashes.
2. Direction indicators indicate the causes of the last three triggers. Set FN = 71, 72 or 73, count direction indicator flashes in series (the
series has been repeated for 5 times with 2 second pause between series) while ignition is OFF or secret button is released.
Meaning of system LED / direction indicators flashes:
1 flash indicates triggering of a sensor;
2 flashes indicate bonnet or luggage compartment opening;
5 flashes indicate turning the ignition ON.
6. CERTIFICATE OF INSTALLATION.
I, undersigned qualified installer
certify that installation of
(Name, Surname)
the below described vehicle alarm system has been carried out by myself pursuant to installation manual supplied by the manufacturer of the system.
Vehicle description:
Manufacturer and model:
Serial number:
Registration number:
Description of vehicle alarm system:
Type: 'GN6I.a'. Model:
Official approval number: 97RA-01 04812
Installation date:
Installing company:
SEAL
Installer:
(Position, signature)
After installation of the alarm system installer must fill in CERTIFICATE OF INSTALLATION! It is recommended to mark selected settings
in the TABLE OF ALARM SYSTEM SETTINGS (underline SN).
7. SUMMARY OF ALARM SYSTEM SETTINGS.
7.1. MARKED FIELD MEANS:
ES – the setting complies with requirements of EU Directives. Selection of settings not complying with EU requirements is permissible
if vehicle is operated in non EU state;
GN6I.a – the setting is in appropriate software version in case the crossover of feature row and version column is marked with or
.
– factory setting.
FN=11
FN=22
NN=1
NN=2
Feature: END OF FN SETTING.
Feature: 'ANTI-CARJACK'*.
'Anti-carjack' is turned OFF.
'Anti-carjack,' triggered upon ignition turn ON or door opening with ignition ON. Countdown (FN=24) begins, and system follows 'anti-carjack' operation setting
(FN=23). Countdown and 'anti-carjack' operation can be cancelled by pressing secret button / turning ON ID card (placing turned ON ID card in service area).
NN=3
'Anti-carjack,' triggered upon ignition turn ON. Countdown (FN=24) begins, and system follows 'anti-carjack' operation setting (FN=23). Countdown and 'anti-carjack'
operation can be cancelled by pressing secret button / turning ON ID card (placing turned ON ID card in service area).
FN=23
NN=1
Feature: OPERATION OF 'ANTI-CARJACK'*.
When countdown (FN=24) ends, the system starts the siren, direction indicators start flashing. After ignition is turned OFF the engine is immobilized and the system
rearms. To cancel the engine immobilization: disarm the system, turn the ignition ON and press the secret button / turn ON ID card (place ID card in service area).
NN=2
When countdown (FN=24) ends, the system starts the siren, direction indicators start flashing. After 10 seconds the engine is immobilized and the system rearms. To
cancel the engine immobilization: disarm the system, turn the ignition ON and press the secret button / turn ON ID card (place ID card in service area).
FN=24
NN=1
Feature: COUNTDOWN OF 'ANTI-CARJACK'.
Turn the ignition ON / press and hold down the secret button. Direction indicators start flashing every 3 seconds. After necessary number of flashes turn the ignition
OFF / release the secret button. By this way the countdown is set (1 flash – 5 seconds, 2 flashes – 10 seconds and so on). Standard countdown is 40 seconds.
FN=25
NN=1
NN=2
Feature: USE OF ID CARD*.
'Anti-carjack' function is optimized for control by secret button. The use of ID card strongly not recommended!
'Anti-carjack' function is optimized for control by ID card. The use of secret button strongly not recommended!
GN6I.a
FEATURE
ES
7.2. TABLE OF ALARM SYSTEM SETTINGS.
40
* – Feature control by ID card is available in case GN6I.a and IMB5 are installed for intercommunication and according settings of the features are selected.