1
Download PDF Version - Product Documentation
Transcript
PackEdge • On Center: The system recalculates the trapping distance for the areas where a trapping area comes too close to the contour of an object. In that case, the trapping area stops halfway the object. In all the other areas, the complete trapping distance is applied. End Caps This option specifies how the ends of an open trap area are constructed. • • • Square: When this mode is selected, the trapping areas are placed at right angles relative to the boundaries of the adjoining color areas. Object Dependant: When this mode is selected the trapping areas are a logical continuation of the contour of the object that is spread (default) Round: When this mode is selected the trapping areas are ended with circular arcs. This mode is typically used in combination with white knockout (= reverse trapping) or ink pullback. Corners This option allows you to change the way sharp corners in the trap areas will be handled. 547 8
