Download Vsigfile User Manual

Vsigfile User Manual V2.0
The Bitmap Connector Dialog
This dialog is invoked by the Set Connector
Position command, or by double clicking on a
connector while the Change Bitmap Size sizing
rectangle is visible.
The name of the selected connector is shown, as are its horizontal and vertical positions. These are
expressed as a percentage of the bitmap's width and height respectively.
Set to Default Position
This box will be automatically checked when the horizontal and vertical positions are the same as if
there was no bitmap, or if they had never been changed. If you manually check this box, the
displayed positions will be set to these values.
Note that connectors at default positions will maintain the same absolute vertical positioning even if
the bitmap size changes, while connectors whose positions have been changed (i.e. non-default) will
always stay at the same place on the bitmap.
Show connector circle
If this box is checked, the normal connector circle will disappear. This may be desirable if the
bitmap image already has suitable connection points. The circle will always be visible when the
connector is selected.
Document Release 2.0
Page 50 of 60
njr 7/25/2002