Download Flume User Manual

Transcript
Evaluation
6.11 Using the Saratoga Data Systems, Inc. public servers
If you can get to and from the Internet with one or more of your test systems and
have an appropriate set of ports (at least two) routed from the Internet to your
test system, we have servers in Santa Clara, California (public.saratogadata.com)
and in Shanghai, China (flume-sh.saratogadata.com). Each of these has a 100
TX full-duplex Ethernet connection to the Internet at 100 Mbps = 12,500 KB/s.
The speedMaximum parameter on each is currently set to 5000 (KB/s) = 40
Mbps.
If you want to try Flume using these systems we will supply you with a login. The
Santa Clara system also has anonymous ftp (read-only) access to a set of test
files that can be transferred for calibration and then for comparison. We currently
(via
scp)
or
have
these
files
in
/disk2/ftp/pub/test-data
ftp://public.saratogadata.com/pub/test-data/ (via FTP)
2M.taz
15M.tar
250M.taz
500M.iso
2G.iso
As of November, 2012 – the default configuration at public.saratogadata.com is
Flume 2.3.
You can confirm the version of Flume installed at public.saratogadata.com with
the following command:
$ ssh [email protected] flume --version
Flume 2.3 User Manual
Proprietary
Page 40 of 54