Download Managed Layer 3 access switch user ManuaL

introduction
Thank you for purchasing the INTELLINET NETWORK SOLUTIONS™ Managed Layer 3
Access Switch, Model 523868.
This is a high-performance managed SNMP switch that provides users with 24 10/100 Mbps
Ethernet and four Gigabit combo ports. The Web/SNMP management provides remote control
capability that gives flexible network management and monitoring options. Whether managed
through an “in-band” SNMP management station, an Internet Web browser or an “out-of-band”
RS-232 console port, the Managed Layer 3 Access Switch facilitates network operational
control and diagnosis.
For increased bandwidth application, it can accommodate up to 32 trunk groups with LACP
link aggregation. Moreover, these trunk ports are set up with a fail-over function to provide
redundant backup if one or more ports are malfunctioning. It also supports both 802.1Q VLAN
and GVRP VLAN registration, thereby simplifying network traffic segmentation, broadcast domain
extension and other associated benefits of constructing VLANs.
The abundance of popular features (highlighted below) translates into increased efficiency and
performance in network administration, and the easy-to-follow instructions in this user manual
help make setup and operation quick and simple.
• Integrated 10/100 Mbps LAN switch with Auto MDI/MDI-X support
• Supports virtual server, port forwarding and DMZ (demilitarized zone)
• Supports DDNS (dynamic DNS)
• Supports VPN pass-through (IPSec, PPTP, L2TP)
• 94 Mbps WAN to LAN throughput for wired networks
• WOL (Wake-On LAN) function sends a wakeup signal to any computer in the LAN
• Integrated scheduler to limit Internet access to client computers in the LAN
• Remote management function (enable/disable and management port)
• Easy installation through Web-based user interface
• Firmware updates via Web-based user interface
• Lifetime Warranty
Package Contents
• Managed Layer 3 Access Switch
• Power cable
• 19” rackmount brackets
• User manual
FCC Warning
This equipment has been tested and found to comply with the limits for a class A device, pursuant
to part 15 of FCC rules. These limits are designed to provide reasonable protection against
harmful interference in a commercial installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communication. Operation of this equipment in a
residential area is likely to cause harmful interference, in which case the user will be required
to correct the interference at the user’s own expense.
CE
This is a class A product. In a domestic environment, this product may cause radio interference,
in which case the user may be required to take adequate measures.
INTRODUCTION