Download "user manual"

Transcript
6 General software functions
Setting for parameter MOPTC:
BUS
DRIVEMANAGER
0
OFF
Monitoring switched off
1
KTY
linear PTC (KTY84-130, tolerance band yellow)
2
PTC
Threshold value PTC with short-circuit detection
(DIN 44081/44082)
- recommended for "Triple-PTC“ -
3
TSS
Klixon (normally closed temperature switch)
41
PTC1
Threshold value PTC without short-circuit detection
(DIN 44081/44082)
- recommended for "Single-PTC“ -
Table 6.34
Function
Setting for the type of motor PTC-evaluation MOPTC
Specification of temperature
sensor connection X3
X3
Specification:
• Measuring range max. 12 V
• Measuring range 100 Ω - 15 kΩ
• Short-circuit detection 18 Ω to 100 Ω
• Cycle time 5 ms
Explanations
• The following temperature sensors can be evaluated:
− linear PTC (KTY84-130, tolerance band yellow)
− Threshold value PTC (acc. to DIN 44081, DIN 44082)
− temperature dependent switch (Klixon)
• If the temperature exceeds a limit value, the positioning controller
switches the motor off with error message E-OTM. The reaction to
the error "Overtemperature motor" can be parameterized. (see
chapter 6.9.1).
• With "KTY84 -130“-evaluation the actual motor temperature is
displayed in the actual value menu (button "Actual values").
• The „KTY84 -130“-evaluation has an adjustable "Motor
temperature" warning threshold, to warn in case of an expected
overtemperature shut-down (see chapter 6.9.2).
• With evaluations by means of KTY84-130 the limit value can be set
with parameter 334-MOTMX "Maximum temperature“.
Application Manual CDE/CDB/CDF3000
6-84