Download CinePlex v2 Manual

Transcript
corner of the image. If the video resolution is other than 1024x768, which is usually the case, the coordinates are linearly mapped onto the video.
To use the Zones Editor
1
On the Tools menu, click Zones Editor.
The Zones Editor window opens.
2
To define a new Zone Interval marker, under the Zone Intervals area click
Add.
The Define New Marker dialog box (see “Define New Marker” on
page 5-187) opens to enable you to customize the general properties of the
new Zone Interval marker.
3
Define the new marker and click OK to close the Define New Marker dialog
box.
A new row appears in the Zone Intervals box.
Note:
Immediately after you create a new Zone Interval marker, Zones Editor enables you to click in the video window to set the X and Y Coordinates of the Selected Zone. The box directly above the video then
contains this text:
Left-Click on the view to add a new coordinate; Right-Click to end
Version 2.0
131