Download User`s manual complete - Sea

SECTION 5
HSMCD7 DOS BASED
SETUP PROGRAM REFERENCE
The DOS based "HSMCD7" set-up program is menu driven, allowing
the user to easily view data, alter set-up variables and set the machine
timing (machine offset, timing signal locations, etc.) using a laptop or
personal computer. The set-up variables are used to configure and
tune the HSMCD7 to match the configuration and performance of the
specific decorator (see Tuning the HSM-CD7, section 2.11).
The main menu of the "HSMCD7" set-up program incorporates the
following menu selections:
Note: The "HSMCD7" program is an on-line communications
program used to interface with the M4503 module. The data
displayed in the menus and set in the menus is communicated directly
to the M4503. Therefore, prior to selecting any of the above
selections, make sure an RS-232 cable is connected from the COM
port on the computer running "HSMCD7" to the "PROG" port on the
M4503.
The following sections are a complete description of the "HSMCD7"
selections and menus.
HSM-CD7 User’s Manual
SYSTEMS Electronics Group
- 81 -