Download Field Manager DisplayUser Guide
Transcript
16 The FieldLevel II Plugin Defining a plane A plane is define by four basic measurements: Description Example 1. An initial point (A). Point A is the hinge point for the main slope. When the main slope is changed in the Plane Leveling Setup screen, the plane will pivot about point A. 2. The heading or direction of the main slope. 3. Main slope (in percent). 4. The cross slope of the plane (in percent). The cross slope plane rotates about the main slope defined by A. A point Heading Main slope Cross slope Note – The design will always rotate about the A point and the main slope as described. However, if you create a benchmark after the design has been defined, the design plane will go through the benchmark height which can change the height of A. The slopes remain the same. 5 16 AgGPS FieldManager Display User Guide
Related documents
CNH FM-1000 Integrated Display
User Guide V4 - Kucera Farm Supply
FmX Integrated Display User Guide
Gemini User Guide
Gemini User Guide - Ag Tech Services
FmX Integrated Display User Guide
FmX Integrated Display User Guide
Symbology Programming
FM-1000 Integrated Display User Guide 9.25A
FmX Integrated Display with the EZ-Pilot
Afs™ - cnh
8200 HP User Manual