Download Firmware Manual
Transcript
TN Vector Tangent Syntax: Implicit Only Operands: _TN Burn: burnable with BN Hardware: DMC40x0 DMC41x3 DMC21x3 DMC18x6 DMC18x2 Full Description The TN m,n command describes the tangent axis to the coordinated motion path. m is the scale factor in counts/degree of the tangent axis. n is the absolute position of the tangent axis where the tangent axis is aligned with zero degrees in the coordinated motion plane. The tangent axis is specified with the VMnmp command where p is the tangent axis. The tangent function is useful for cutting applications where a cutting tool must remain tangent to the part. Arguments TN m,n where m is the scale factor in counts/degree, in the range between -127 and 127 with a fractional resolution of 0.004 m = ? Returns the first position value for the tangent axis (same as _TN). When operating with stepper motors, m is the scale factor in steps / degree n is the absolute position at which the tangent angle is zero, in the range between -8388608 to 8388607. Operands _TNn (where n = S or T) contains the first position value for the tangent axis in the specified vector plane. This allows the user to correctly position the tangent axis before the motion begins. Note, _TNn will change based upon the vector path described in the VM declaration. See the example below. Usage Usage and Default Details Usage Value While Moving Yes In a Program Yes Command Line Yes Default Value N/A Related Commands VM - Vector mode CR - Circle Command VP - Vector Position Examples
Related documents
Galil Motion Control Command Reference
AMPERR Amplifier error automatic subroutine
Rev 1.0f
RIO-47xxx User Manual - Galil Motion Control
COMMAND REFERENCE - Galil Motion Control
Galil RIO-47100 Command Reference
AMPERR Amplifier error automatic subroutine
RIO-47100 Command manual
DMC-41x3 User Manual - Galil Motion Control
DMC-500x0 User Manual - Galil Motion Control
DMC-30000 User Manual - Galil Motion Control
Galil DMC-1400 User's Manual