Download Firmware Manual

Transcript
TN
Vector Tangent
Syntax:
Implicit Only
Operands:
_TN
Burn:
burnable with BN
Hardware:
DMC40x0 DMC41x3
DMC21x3 DMC18x6
DMC18x2
Full Description
The TN m,n command describes the tangent axis to the coordinated motion path. m is the scale factor in
counts/degree of the tangent axis. n is the absolute position of the tangent axis where the tangent axis is
aligned with zero degrees in the coordinated motion plane. The tangent axis is specified with the
VMnmp command where p is the tangent axis. The tangent function is useful for cutting applications where
a cutting tool must remain tangent to the part.
Arguments
TN m,n
where
m is the scale factor in counts/degree, in the range between -127 and 127 with a fractional resolution of 0.004
m = ? Returns the first position value for the tangent axis (same as _TN).
When operating with stepper motors, m is the scale factor in steps / degree
n is the absolute position at which the tangent angle is zero, in the range between -8388608 to 8388607.
Operands
_TNn (where n = S or T) contains the first position value for the tangent axis in the specified vector plane.
This allows the user to correctly position the tangent axis before the motion begins. Note, _TNn will change
based upon the vector path described in the VM declaration. See the example below.
Usage
Usage and Default Details
Usage
Value
While Moving
Yes
In a Program
Yes
Command Line
Yes
Default Value
N/A
Related Commands
VM - Vector mode
CR - Circle Command
VP - Vector Position
Examples