Download advanced - GFC AntriebsSysteme

Transcript
CANopen interface
User manual
3.4.5 Reference operation mode (Homing Mode)
The drive performs a reference operation. The settings of the parameters (index 2105 H reference
operation parameter) are used. The reference type and speed can be overwritten by the standard
CANopen indices (homing_method and homing_speeds).
Only one speed is used for approaching and passing the reference point (homing_speed, subindex 1).
Seven different reference operation types are available in the MDA reference operation management.
They are shown in CANopen in combination with the reference setting "Passing direction' as indicated
below.
3.4.5.1
Reference operation types
CANopen Standard:
35
23h
23-26
17h – 1Ah
27-30
1Bh – 1Eh
19
13h
20
14h
2, 18
2h, 12h
Reference operation type
None
Marker
Passing direction
None
negative
positive
negative
positive
(cannot be set, negative)
Flank
Limit switch positive
1, 17
1h, 11h
Limit switch negative
Manufacturer-specific Reference operation type
-1
FFh
No reference operation, reference is set to
the value entered in the reference offset.
-2
FEh
Reference memory, reference bit and
actual position are restored from the
memory.
3.4.5.2
None
Operation mode-specific bits in the control word:
Bit
0
1
2
3
Value
1
0
1
0
1
0
1
0
4
5
6
7
15
Meaning
Remarks
switch on
enable voltage
quick stop
enable operation
Homing operation start
1
0
1
0
8
9
10
11
12
13
14
20
(cannot be set, positive)
Passing direction
None
reserved
reset fault
reserved
1
0
remote request
GFC AntriebsSysteme GmbH