Download StaRRsed Flex User Manual

Assemble fill nozzle holder:
Assemble fill-nozzle:
Push the plastic top part down against the
spring pressure.
1. Connect the silicon tube to the fill
nozzle.
2. Put the fill nozzle into the holder.
3. Push the fill nozzle upwards and turn
the holder to the left.
1. Turn the plastic top part until you hear
of feel a click
2. Turn the plastic top part clokwise for
1.5 turns.
2. Clean Liquid Separator and exchange filters
Removing
1. Open the left cover and remove the waste container. The
liquid separator is now visible.
2. Lift the stainless steel vacuum tube with use of the lever.
3. Pull the liquid separator towards the front of the Compact.
(Note: The separator has two sensor connectors at the
rear)
4. Disconnect the silicon tube from the tube connection on
the top section.
5. Remove bacterial HEPA filter.
6. Remove and disassemble the liquid separator.
Cleaning
1. Clean all parts with hot water and a brush.
2. Use some acid free vaseline on the screw-thread of the
glass jar.
3. Assemble the separator.
StaRRsed Flex User Manual
Version 1.02 MRN-151-EN
Page 329