Download B - Schneider Electric

Managing the dedicated AXE zone
4
__________________________________________________________________________________________
4.2 Directory
__________________________________________________________________________________________
An axis control application is defined by :
• an axis (or module) number from 0 to 63,
• an application number from 0 to 8.
It is the directory which defines the correspondence between the geographic position of
the modules in the I/O configuration and the logic numbers.
Created by PL7-AXE, the directory is stored initially in the dedicated AXE zone of the
PLC memory. The first 64 AXM modules in the I/O configuration are allocated an axis
number from 0 to 63 in ascending order.
The allocation of these numbers may be modified by the user.
If PL7-AXE is operating in connected mode (AXM MEMORY or TSX/PMX MEMORY),
the [DIR AXIS] soft key will display the AXIS DIRECTORY screen (or enable this
directory to be created).
TSX/PMX-AXM space
RESERVED
The number of reserved words is fixed by XTEL-CONF. This number
cannot be modified by PL7-AXE.
FREE
The number of free words represents the memory area not used.
TSX FILE
AXIS.BIN is the name under which the dedicated AXE zone is stored
on disk using the [STORE] command.
__________________________________________________________________________________________
4 / 3
C
2