Download Digilock 110
Transcript
Feedback Controlyzer DigiLock 110 10.2.2 Top of Fringe Locking (Lock-In) To lock the laser to a maximum of the Doppler-free absorption signal, a zero crossing slope is generated using frequency modulation. The Lock-In module uses a modulation frequency smaller than the characteristic resonance width to obtain the derivative of the absorption signal by demodulation. For the setup follow the initial steps 1. to 18. described above, but choose <LI out> as input to the AutoLock module. 21. To view the error signal switch to AutoLock display. Set the scan frequency of the Scan module to 10 Hz, the output to <SC 110 out> and switch on the scan. Figure 47 Lock-In Module with typical Parameters 22. Configure the parameters for the Lock-In module (see Figure 47). The modulation set frequency (Set freq) has to be chosen depending on the spectral resonance. A reasonable choice is about 1/10 of the characteristic linewidth. In this example a frequency of about 100 kHz is used. Due to the specific architecture of the DigiLock 110 only discrete frequencies are possible. Type in the desired one and the system will automatically determine the nearest one available (Act freq). 23. Turn on the modulation by pressing the ON/OFF button. The second trace should now display the error signal derived from the frequency modulation. The modulation amplitude is a trade-off between the desired lock-in signal strength and the allowed frequency modulation of the laser. The larger the amplitude, the larger the lock-in signal but note that at the same time the sidebands on the laser increase13. Figure 48 shows the resulting Scope display (with optimized phase). 13. This tradeoff can be eliminated by using an additional electro-optical modulator (EOM) in the locking beam path after splitting from the main beam. Page 56 Status: 9.6.09