Download the instructions

40
Programming Manual
SATEL
disabled for 16 seconds. If, after the power is turned on again, another violation from the
fire zone occurs, the fire alarm will be triggered.
12. POWER SUPPLY ON ARMED – the dedicated output for power supply of the detectors which
should not be active when the system is disarmed. It gets activated at the moment of
starting the arming procedure (the exit delay is not taken into account).
13. ZONE VIOLATION – signals violation of the zones.
14. CHIME – signals violation of the zones when they are disarmed.
15. CONTROLLED – controlled by means of zones, timers, keypad or from keyfob.
16. READY STATUS – indicates whether the system is ready for arming, i.e. whether there are
no violated zones (active when there is no violation).
17. EXIT DELAY STATUS – indicates that the EXIT DELAY countdown is running.
18. ARMED STATUS – indicates the armed mode (after completion of the exit delay countdown).
19. TROUBLE STATUS – indicates troubles.
20. ALARM/ARM STATUS – indicates alarms (pulsating mode) and arm status (continuous mode
– after end of the exit delay countdown).
21. DETECTORS RESETTING – dedicated output to control the alarm memory reset in detectors.
Activated at the moment of starting the arming procedure (the exit delay is not taken into
account). It can also be activated by using the OUTPUTS RESET user function.
6.3
Output parameters
Fig. 10. "Versa – Outputs" window in the DLOADX program.
Output name – individual name of the output (up to 16 characters).
Cut-off time – time during which the alarm outputs and the outputs with functions 13. ZONE
VIOLATION, 14. CHIME, 15. CONTROLLED and 21. DETECTORS RESETTING are active. Entering
the value 0 modifies the way of functioning of some outputs:
– alarm outputs remain active until the alarm is cleared,
– the 13. ZONE VIOLATION output remains active throughout the time of zone violation (the
PULSE option is disabled then),
– the 14. CHIME output remains active until deactivated by the OUTPUTS RESET user
function,