Download LEDs - H3C

The directions "front", "rear", "left", "right", "bottom" referred to in this document are defined on the
assumption that the device is normally positioned and you face the front panel of the device.
z
The VX1500 shall be used indoors as a fixed device.
z
Do not remove the H3C tamper-proof seal (shown in Figure 3-2) on the chassis cover of the device
without permission. If you want to open the chassis, you should contact the local agent of H3C for
permission. Otherwise, H3C shall not be held liable for any consequence caused thereby.
Figure 3-2 Tamper-proof seal
Installing the Accessories
This section covers two parts: installing the power cable latches and installing the mounting brackets
(required when the device is mounted in a standard 19-inch rack).
Installation Flowchart
Figure 3-3 shows the flow of installing the accessories of the VX1500.
Figure 3-3 VX1500 accessories installation flowchart
Start
Install the power cable
latches
Install mounting
brackets on the chassis
(rack-mounted)
Verify the installation
End
3-2