Download NO.1.1 CONTROL SYSTEM

Power-on and Start-up
Ensure the following items before powering on and starting up the laser engraving machine
for the first time:

The input power supply should comply with the equipment standard.

Every line is connected properly, especially that the high pressure connector of the
laser tube should be placed on the insulator bracket.

Both the machine and computer device should be grounded safely.

The inlet and outlet pipe should be connected properly to ensure smooth water
circulation.

The air compressor and tube are connected properly to blow air regularly.

Irrelative items cannot be placed on the worktable.
The machine can be started to work after it is confirmed that no error is involved in the
items above. After power-on, the system starts auto check, initialization, and resetting, while the
LCD screen displays the start-up interface as shown in F3-51. During initialization, only the
“E-stop” key is available. The other keys are inoperative. The start-up interface shows our LOGO
on the top right corner and “
Han’s YMLaser” and “Ver 3.0.8”, the
software version number of the current operation panel.
大族粤铭激光
Han’ s YMLaser
Ver 3.0.8
Fig.3-51 Start-up interface
After initialization, the system automatically enters the standby mode, while the main
interface appears on the LCD screen, as shown in F3-52
File: YMLaser
Time:00:00:00:00
Number:0
LOFF
Fig.3-52 Main interface
As shown in F3-52, the main interface covers the following content:

The logo of Han's Yueming Laser Technology Co., Ltd. on the top right corner.

The name of the file processed currently or last time on the second line. If you carry
out “Carve out” operation, it displays “YMLaser”, the default file name (as F3-52), or
the name of the selected file.
63