Download NO.1.1 CONTROL SYSTEM

File1
File2
File3
File4
Fig.3-72 File list interface
No File!
Fig.3-73 No File Prompt
There may be the following two warnings when reading the files from a USB disk, as shown
in F3-74:
Data Transmit！
No Disk!
Fig.3-74 (a) No Disk Prompt
(b) Data Transmit Warning

As shown in F3-74 (a), the system prompts “No Disk” when it doesn’t detect a USB disk.
Solution: Re-insert the USB disk. If it still doesn’t work, please check whether the disk is
write protected and whether the file system of the disk is FAT or FAT32. The file list in
the disk can be only read when the write protection is removed and the file system is
FAT or FAT32.

As shown in F3-74 (b), the system prompts “Data Transmit”, indicating that the USB
disk cannot be read for this moment, because the computer is carving out or
downloading file to the card. Please wait the completion of data transmitting to
operate the USB disk.
Note
Processing files are in “*.oux” file type. When reading the “U Disk
File”, only those files in “*.oux” file type can be displayed, while
other files cannot.
In the file list interface, you can perform the following operation:
1)
Press the “Up/Down” key to select a file.
2)
Press the “Left/Right” key to page up/down.
78