Download Installation and Reference Manual

Reconfigure the PC
2. Set the desired DHCP Port number.
3. Do not forget to enter the administrator administrator Password.
4. Run the vi by pressing the start
dialog.
button. It should finish without opening an error message
5. Turn the Licel Multispectral Lidar Detector off and switch it on again. Wait approximately 20 –
30 seconds.
6. A ping 10.49.234.234 executed from a command prompt (DOS box) should now time-out.
4.4
Reconfigure the PC
After you successfully configured the Licel Multispectral Lidar Detector the following last steps have
to be carried out to reconfigure your PC for the local network and to test the connection to the Licel
Multispectral Lidar Detector:
1. Reconnect the PC to the local network.
2. Open the Properties dialog of the network connection your ethernet adapter is assigned to. A
more detailed instruction has been given above.
3. Open the Properties dialog of the TCP/IP protocol entry in the lists of components used by the
assigned ethernet adapter card.
4. Reset your current TCP/IP settings to the values you recorded while processing the subsection
to establish a network connection.
27