Download Modeling Tools Version 2.0 User`s Manual

Transcript
Modeling Tools 9
Entering Parameters for the N vs t and N(t) vs N(t+m) Plot Modes in the
“Initialize & Plot” Dialog Box:
Figure A2. Dialog box for entering parameters for logistic growth model.
After selecting the “Initialize & Plot” option (see Figure A8 below), a dialog
box will appear through which parameters and a specification of the simulation
experiments to be run can be entered. Upon selecting “Initialize & Plot,” default
parameters will appear as shown in Figure A2.
On the left side of the dialog box illustrated in Figure A2 the model parameters
of the minimum density limited logistic growth equation are listed: the initial
population size N at the start of a simulation, population growth rate r, the Carrying
Capacity k of the environment for the population, and the minimum size C of the
population which can sustain growth.
The fifth parameter of this model is the change in time parameter called “∆t,”
the default value of which is set at 1. The parameter ∆t must be set so that ∆t ≥
0.0025, since one can’t do less than one generation; this value will generate 400 points
in that one generation.1 When ∆t = 1, this can be interpreted as reproduction
occurring synchronously once each generation. As ∆t decreases, population growth
becomes more like continuous growth over a generation. Increases in ∆t increase the
time lag from when population size feeds back (through density-dependent effects)
to affect growth rate. The further significance of this variable is discussed in the
Modeling manual text for the minimum density limited logistic simulation.
1
Constraints on memory (and the desire to do up to 10 runs) limit the number of point plotted to 400
per run (see below), for a total of 4000 points per graph.