Download XSCF User`s Guide

62:Config
[: Unit
configuration
change]
71:DevState
[: Unit status
display]
C0:Console
[:
Console
event]
C1:Access
[: SCF access
event]
Detailed code:
x01mmqqss yyyyyyyy yyyyyyyy yyyyyyyy yyyyyyyy
Explanation: A part was added. mm indicates the part name number, qq the part
number, ss the old unit status, y’s the the serial number after replacement without FAN or
PSU.
The definition of mm is as follows:
― x02 : Fan
― x03 : PSU
― x05 : Panel
― x06 : SB
― x10 : CPU
― x11 : Slot
― x12 : PCI-BD
― x13 : SCSI-BD
The definition of ss is as follows: (The ss is zero when mm is FAN or PSU.)
The ss the old unit status : 0
7
― bit 0 : valid bit
― bit 1 : Mount information
― bits 2-3 : Reserved
― bit 4 : Alarm level
― bit5 : Warning level
― bit6 : Notice level / Standby level
― bit7 : Sensor abnormal
Detailed code:
x02mmqqss yyyyyyyy yyyyyyyy yyyyyyyy yyyyyyyy
Explanation: The part was removed. The definitions from mm to ss are the same as
described above. y’s the the serial number before replacement without FAN or PSU.
Detailed code:
x81mmqq00
Explanation: A fault part was added. The definitions from mm to qq are the same as
described above.
Detailed code:
xqqqqqqqq
Explanation: The status of the unit was displayed.
qqqqqqqq indicates the
unit-dependent command parameter.
Detailed code:
xVVpp0000
Explanation: A console event occurred. VV indicates the detailed event. pp indicates
the switching source.
The definition of VV is as follows:
― x01 : The console was switched from the TTY-A console to the SCF-LAN
console.
― x02 : The console was switched from the SCF-LAN console to the TTY-A
console.
The definition of pp is as follows:
― x00 : The console was switched by Machine Administration Menu.
― x01 : The console was switched by SCF Shell.
Detailed code:
xVVmm0000 xxxxxxxx yyyyyyyy yyyyyyyy
Explanation: An SCF access event occurred. VV indicates the access type, mm the
login/logout status, xxxxxxxx the IP address of the access source, and yy.... the account
name.
The definition of VV is as follows:
― x10 : Access to XSCF by telnet RW.
― x12 : Access to the telnet shell.
― x20 : Access to the SSL.
― x21 : Access to the HTTP.
― x40 : Access to the serial port.
― x50 : Access to the SSH RW(port 22).
― x51 : Access to the shell(port 8810) by SSH.
― x52 : Access to the SSH RO(port 8811).
― x53 : Access to the SSH RO(port 8812).
The definition of mm is as follows:
― x01 : Logged in to the SCF.
― x02 : Logged out from SCF.
― x03 : SCF forcibly disconnect user session due to inactivity timeout.
B-71
All Rights Reserved,Copyright (C) FUJITSU LIMITED 2003,2004