Download XSCF User`s Guide

Chapter 10
XSCF Firmware Upgrade and Dump
3. Select “HCP File Operation”, then select “Show/Register the Supply HCP”.
“Work Area”, and register the firmware by the Machine Administration Menu.
(In this state, it is not upgraded yet.)
Select
4. Do the No.5-7 of above “Registration from CD-ROM”.
● Registration from applying of the ESF patch
1. When the following Patch is offered, "Patches application" is done.
Patch ID : 913034-xx
Package name : FJSVhcp
Patch Name : Enhanced Support Facility 2.X : Hardware Control Program patch
(X is 3 or more.)
Patch file name : 913034-xx.tar.Z
You can obtain the patches data as follows.
― Download the patch from Our Site and apply patch.
― Apply patch included in the ESF Patches CD-ROM.
When you apply patch by the ESF Patches CD-ROM, about the application method,
see “Applying patches” of “About patches for the Enhanced Support Facility 2.3 and,
Documentation Errata” in the ESF Patches CD-ROM.
Note:
See Readme file of the patch in Our Site or the ESF Patches CD-ROM. And please be
sure to check HCP version and contents of upgrade. When there is necessary related
software to apply at the same time, you have to apply those patches. About the
application method, see the document of each patches.
2. Download the patch file and extract the file to an arbitrary directory in the server which is
applied the patch.
3. Use the “patchadd” command, and register the patch.
# patchadd 913034-xx
Checking installed patches...
Verifying sufficient filesystem capacity (dry run method)...
Installing patch packages...
Patch number 913034-xx has been successfully installed.
See /var/sadm/patch/913034-xx/log for details
Executing postpatch script...
COMPLETE
Patch packages installed:
FJSVhcp
10-4
All Rights Reserved,Copyright (C) FUJITSU LIMITED 2003,2004