Download XSCF User`s Guide

Chapter 3 Connecting XSCF or Server
● When a URI is specified in the browser, the XSCF Web
function can be used.
Serial port
(tty-a)
● XSCF shell terminal
― The XSCF shell can be used by entering a keyword
for XSCF.
― Screen switching to and from the standard console
can be done.
Note: After login, if the XSCF shell has not been accessed for
a predetermined time, the user is forcibly logged out.
● Standard console
― OS console input and output is enabled. Note,
however, that the standard console cannot use the
XSCF shell in a telnet connection.
― Screen switching to and from the standard console
can be done.
SSL : 443
－
Note:
Please
set
the
Standard console to
the "serial port" by
the
"Console
Administration"
of
the
Machine
Administration Menu.
(The default port
when it's shipped
from factory is the
serial port (tty-a). )
Note:
For a single server, since no more than a total of two terminals can be connected at the same
time to the XSCF shell via the serial port (tty-a) and the LAN port, only two users can use the
XSCF shell at the same time.
Caution:
When using the XSCF shell simultaneously on the LAN port and serial port, note the following:
● If different power or reset instructions are received from the ports, the previous operation,
such as power-off after power-on, may be canceled.
Connecting to XSCF using telnet via the LAN port
The procedure described in this section assumes that the XSCF initial settings described in
"Chapter2 Setting Up XSCF" have been completed. For the connections between XSCF and
PC/workstation with LAN cable, see the User's Manual for the server.
The following is the procedure for connecting to a terminal using telnet via the LAN port:
1. Make sure that the LAN cable from the HUB is connected to the SCF-LAN port connector
on the rear of the server. Comfirm the secure connection to the PC or workstation, also.
2. On the PC or workstation to be used, use one of the following procedures:
3-4
All Rights Reserved,Copyright (C) FUJITSU LIMITED 2003,2004