Download X-Monkey User Manual

Transcript
3.11 MPU-9150
X-Monkey has pads that allow an MPU-9150 to be installed. This component is new, and is not yet
on the stock X-Monkey.
3.12 ADC and GPIO
Connector X1 is a mix of ADC (buffered and unbuffered) and GPIO signals.
3.13 Communication ports
Main com is on X1, this is UART 0. Spare com (UART1) and UART3 (formerly called “CHIMU com”)
are on connector X3. UART1 can be routed thru the RS-485 driver to the same connector. The RS485 chip can be completely turned off via power control to the chip to save power in sleep modes.
X-Monkey User Manual Rev - | Schematic Details
22