Download 638 Series - HVS System

Safety Precautions
Please
Observe !
Pay Special Attention to the Following:
Permissible Protection Class: Protective Grounding - operation is only permitted
when the protective conductor is connected according to regulations.
Operation of the servo drive when employing a residual current operated
protective device as the sole protection against indirect touching, is not
permissible.
The servo drive may only be used in conjunction with machines or
electrical systems when placed in control cabinets which comply with
EEC- Directive98/37EEC (Machine Directive) and
EEC Directive 89/336/EEC (EMC – Directive).
Work on or with the servo drive may only be carried out with insulated tools.
Installation work may only be done in a de-energized state. When working on
the
drive, one should not only block the active input, but also separate the drive
completely from the main power connection.
CAUTION - Risk of Electrical Shock:
Wait 3 minutes after switching the component off to allow the capacitors to
discharge.
Screws sealed with varnish fulfill an important protection function and may not
be
tampered with or removed.
It is prohibited to penetrate the inside of the unit with objects of any kind.
Protect the unit from falling parts, pieces of wire, metal parts, etc., during
installation or other work in the control cabinet. Metal parts can lead to
a short-circuit in the servo drive.
Before putting the unit back into operation, remove any additional covers so that
the unit does not overheat. When conducting measurements on the servo drive
it is imperative to pay attention to the electrical isolation.
We are not liable for damage which may occur when the product
instructions and/or the applicable regulations are not explicitly observed!
Stop !
10
07-02-12-02-EN-V0608.doc / Type: 638