Download User Manual

www.ismartcharger.com
●MODE, function mode switching.
●CURRENT, select button, choose the charging or discharging current, and timer function.
●DISPLAY, display mode for voltage, current, capacity, work time and internal resistance.
6. Detailed operation procedures
（a）Four ports set and operate at the same time:
●After putting in batteries, long press any keys (1\2\3\4) for 1.5 seconds, it toggles to the
function select, the characters in the display area begins to flicker.
●There are six function modes to select. Such as charge, discharge, charge refresh, charge
test, repair, and timer. You can toggle to six function modes by pressing MODE key.
●After function setting, you can press 1/2/3/ 4 to save the settings. If it stays for 5 seconds
without pressing button, it will save and exit automatically.
●The function will change to the current function mode if four ports are in the different
mode.
(b) Single port setting
●After putting in one battery, you can press any buttons (1, 2, 3 or 4), the characters in the
display area of corresponding port begins to flicker. For example, if you press 1, the
characters in 1 will begin to flicker. There are six function modes to select. Such as charge,
discharge, charge refresh, charge test, repair, and timer. You can toggle to six function
modes by pressing MODE key.
●After function setting, you can press 1/2/3/ 4 to save the settings. If it stays for 5 seconds
without pressing button, it will save and exit automatically.
7. Detailed mode setting
●CHARGE
The default charging current is 500mA. It can provide four types of charging current
200mA, 500mA, 700mA, 1000mA, 1500 mA for four ports charging, and five types of
charging current 200mA, 500mA, 700mA, 1000mA, 1500 mA for single port charging. The
charger goes into CHARGE mode by single port or four ports setting. When CHARGE
displays, press CURRENT button to charge and choose charging current. After selecting the
proper current, press MODE button then cannot switch mode, save the setting by press
1/2/3 /4 or staying 5 seconds without pressing any button. If batteries are fully charged,
the charger will display FULL.
●DISCHARGE
The default discharging current is 350mA. . It can provide four types of discharging current
100mA, 250mA, 350mA and 500mA. The charger goes into DISCHARGE mode by setting
single port or the four ports. No matter what characters the four ports display, just press
CURRENT button to choose discharging current. After selecting the proper current, press
Email: [email protected]
Tel: 0086 755 28894365 Mobile: (0086) 13728871681