Download User Manual - Excalibur Engineering
Transcript
Using Functions Testing a Dual Band Mobile with MANUAL TEST (Synchronous mode) • If the MS Call softkey is pressed, the following screen is displayed. Dial and call from the mobile to proceed to the Talk/RF Test step. You can measure the DC Current at Camp On stage while the MS Call step is blinking. Step 14. Upon setting up the call setup, the Talk/RF Test screen is displayed as shown below. IMSI, IMEI, Power Class, GSM Version, RX Quality, RX Level are shown. For MS Call, Dialed No. is also included. 2. Using Functions Step 15. While the Talk/RF Test step is blinking as above, you can select a test item by the CURSOR CONTROL knob to execute its test. Place the cursor at “Peak TX Power, Burst Timing, Power Ramp” and press the CURSOR CONTROL knob, for example, to obtain the next screen. Step 16. Press the Abort softkey to get other softkey menus. Chapter 2 37