Download SolarPak Manual

SolarPak User’s Guide
5.2 Pole Mounting
The pole-mountable bracket is designed for small-diameter poles (2" to 3.5"/50 mm to 89 mm).
1. Place one pole-mount bracket against the pole and one wall/pole-mount plate on the other
side of the pole.
Note: The height of the bracket and mounting plate should be set so that the SolarPak
assembly is at the desired height when the heads of the top four M6 screws on the backside of
the enclosure are inserted into the corresponding keyholes on the mounting plate.
2. Slide a spring washer and steel washer onto each of the M8*8 bolts. Tightly fasten the bracket
to the mounting plate with four M8*80 bolts.
3. Adjust the height of the bracket and mount plate to align with the bottom four M6 screws on
the back of the enclosure.
4. Support the weight of the SolarPak assembly and insert the top set of four M6 screws on its
backside through the corresponding holes on the top wall/pole-mounting plate.
5. Do the same for the bottom set of four M6 screws.
Note: Ensure the M6 screws are firmly inserted in each hanging notch before letting the wall/pole
mounting plate fully bear the weight of the SolarPak assembly.
Pole Mounting Bracket
M8 bolts
8