Download PlanIT 3.1 User Manual

4.4 Feature Types And Layers
Each layer has a feature associated with it, and the attributes of the layer
can be edited in the Feature Types list. For example, in the above
example, the Boundary Area layer is denoted by a cross-hatch, but you
may prefer to make it a solid colour which obscures information on layers
below it. This can be changed:
1. Click on Lists > Feature
Types
2. Select Area from the drop
down Category list.
3. Select Boundary from the
list of features.
4. Click on Edit.
5. Select FDiagonal from the Area Pattern drop
down list.
Changing the Boundary Area from a solid
colour to a pattern will allow lower layers to
be seen.
6. Select a light colour from the Colour drop
down list which will be easy to see over the
top of the lower layers.
7. Note the Show Area and Show Label boxes
are ticked. The Show Label tick box refers to the Field name and the
Show Area tick box refers to the area displayed in brackets. If the
box is not ticked, then that information will not be displayed.
8. Click on OK, then OK again.
PlanIT 3.1 User Manual
P/n 1-1248
Page 50
Rev A