Download netJACK Communication Module

Introduction
1.1.2
7/154
List of Revisions
Index
Date
Chapter
Revision
1
2011-02-03
all
Created
2
2012-03-30
1.4
Section Ensuring Access Security added
5
Note added, stating that interfaces can only be used by one software at the same
time.
11.1
Mounting/pulling cycles added
3
4
2012-07-11
2013-12-19
12.1
Section EtherNet/IP Adapter/Slave – Instance ID of I/O Data added
9.4.2.2
LED Description of EtherCAT slave updated
11.2.4
Technical Data of EtherNet/IP adapter protocol updated
11.2.11
Technical Data of Sercos slave protocol updated
11.3.2
Technical Data of CANopen slave protocol updated
5
Instructions for installing software were taken out of this document. Instructions for
installing software can now be found in separate User Manual Software Installation
comX and netJACK, DOC130405UMxxEN.
1.2.1
Section Important Changes containing information about new firmware versions
added
all
New devices added:
NJ 10D-COS
NJ 10D-CCS
NJ 10D-DNS
NJ 10D-DPS
NJ 51D-RE
NJ 100DN-RE
NJ 100DN-CO
NJ 100DN-DN
9.4
LED Descriptions for the following protocols updated:
DeviceNet Master
DeviceNet Slave
Sercos Master
Sercos Slave
11.1
Section Technical Data of the netJACK Communication Modules updated.
11.2
Technical data of the following Real-Time Ethernet protocols updated:
EtherCAT Slave
EtherNet/IP Scanner
EtherNet/IP Adapter
PROFINET IO Device (V3.5)
Sercos Master
Sercos Slave
11.3
Technical data of the following fieldbus protocols updated:
CANopen Slave
CC-Link Slave
PROFIBUS DP Master
Table 1: List of Revisions
netJACK Communication Module | Installation, Operation and Hardware Description
DOC110504UM04EN | Revision 4 | English | 2013-12 | Released | Public
© Hilscher, 2011 – 2013