Download CountyDam® - Pre-Engineering Software

Transcript
Interpretation of Results
To keep the joint from failing due to normal stress on
a vertical joint, limit the stress to the following:
Interpretation of Results
Max allowable tensile stress = 6 psi
Max allowable compressive stress = 170 psi
Sv - This is the shear stress on the joint. This stress is
a direct result of the reactive kick from the soil trying
to move the blocks to the right of the joint vertically
with respect to the blocks at the left. Use the absolute
value of the number and limit it to the allowable shear
stresses below:
For filled block:
For hollow block:
Max allowable tensile stress = 12 psi
Max allowable compressive stress = 215 psi
The maximum allowable shear stress = 6 psi
For hollow block:
For filled block:
Snb - This is the normal stress at the bottom of the
vertical joint. A positive number indicates tension or
a pulling apart of the joint. A negative number
indicates compression or tightening of the joint. To
keep the joint from failing due to normal stress on a
vertical joint, limit the stress to the same allowable
stresses given for Snt.
The maximum allowable shear stress = 6 psi
The vertical joint stresses are not available (NA) when
the allowable soil stress has been exceeded. Failure
has occured in the soil before failing the joint.
__________________________________________________
9-15
__________________________________________________
9-16