Download CountyDam® - Pre-Engineering Software
Transcript
Interpretation of Results To keep the joint from failing due to normal stress on a vertical joint, limit the stress to the following: Interpretation of Results Max allowable tensile stress = 6 psi Max allowable compressive stress = 170 psi Sv - This is the shear stress on the joint. This stress is a direct result of the reactive kick from the soil trying to move the blocks to the right of the joint vertically with respect to the blocks at the left. Use the absolute value of the number and limit it to the allowable shear stresses below: For filled block: For hollow block: Max allowable tensile stress = 12 psi Max allowable compressive stress = 215 psi The maximum allowable shear stress = 6 psi For hollow block: For filled block: Snb - This is the normal stress at the bottom of the vertical joint. A positive number indicates tension or a pulling apart of the joint. A negative number indicates compression or tightening of the joint. To keep the joint from failing due to normal stress on a vertical joint, limit the stress to the same allowable stresses given for Snt. The maximum allowable shear stress = 6 psi The vertical joint stresses are not available (NA) when the allowable soil stress has been exceeded. Failure has occured in the soil before failing the joint. __________________________________________________ 9-15 __________________________________________________ 9-16