Download dotPLOT 6000-Series User Manual with Notes on

Transcript
Page 7 of 75
2.
Installation
DOTPLOT IS A DOS PROGRAM. THIS IS NOT A DOS TUTORIAL. IF YOU ARE NOT
CONVERSANT WITH DOS FILES, DIRECTORIES, COMMANDS AND BATCH FILES THEN YOU
SHOULD USE THE WINDOW INTERFACE, HOTPLOT.
THIS IS NOT A WINDOWS TUTORIAL EITHER. IF YOU ARE NOT CONVERSANT WITH BASIC
WINDOWS CONCEPTS LIKE FILES AND FOLDERS THEN YOU SHOULD GET OUTSIDE HELP.
2.1
Summary
• Install dot6000 (usually on a machine connected to a LaserJet). The program must be installed on
the C: DRIVE – it will not run from any other drive.
• Alternatively, if you prefer a Windows interface, install HotPlot: It can then do the installation of
dot6000.
• Test dot6000, through HotPlot if you are using it.
• Enter the licence details, obtain and save the licence file. For details see Section 2.5 below on
page 11 (The Licensing Process) and subsequent sections.
• Perform any customisation such as changing the page layout (Chapter 5 below starting on page 46
– Customising dot6000) and adding your own Logo (Section 5.10 below on page 55).
Lack of a valid licence will cause the banner “DEMO” to appear on printouts. The banner will
darken with age.
2.2
Installing the System
2.2.1
Installing the Combined HotPlot/dotPLOT Package
If you are not using HotPlot, ignore this section and skip to the one directly below.
The program can be downloaded from the Internet as an executable file HotPlotSetup.exe.
1.
Click the Internet hyperlink, found near the top of the page
http://www.softwareafrica.co.za/dotplot-setup.htm
2.
A pop-up window will ask if you want to Save or Run the program. Choose Run. (for
multiple PCs, you can Save it and then Run it later on each PC)
3.
Wait until the program has downloaded.
automatically, close it.
4.
The WinZip Self-Extractor will appear, ask for an "Unzip to" folder, and offer C:\dotSetup as
the default.
5.
Click the Unzip button. NB: You must use C:\dotSetup and not change to anything else! If
your PC does not have a C: drive, contact us for an alternative Setup.
6.
The WinZip Self-Extractor will say: "10 file(s) unzipped successfully". Click OK and Close.
7.
Run "My Computer" or Windows Explorer (shortcut: "Windows key"
8.
Open the folder that you unzipped to, i.e. C:\dotSetup
9.
You should see a program, SETUP.EXE (If you see SETUP, not SETUP.exe, you have file
extensions turned off –this is OK, but don't confuse it with SETUP.LST which is also there).
10.
Double-click SETUP.EXE to run it.
dot6000 User Manual
If the Download window does not close
©Winston Jones & Software Africa
+ E ).
19 August 2010